Kainan Pewitt

Use Job print to set new poles for pole harding project for duke energy

Pull in new 795 phases and 336 neutral

Hang new wye wye 120/208 and wye delta 120/240/208 three pot banks.

Transfer load

Wreck out old wire and Poles

Take outages on 3 phase 1/0 dip Poles

• Maintained solid safety record with no OSHA-recordable incidents.
• Worked on both dead and energized lines.
• Installed and maintained overhead and underground electrical power lines and auxiliary equipment.
• Responded to emergencies and outages that required additional labor and assistance for repairs.

• Maintained solid safety record with no OSHA-recordable incidents.
• Worked on both dead and energized lines.
• Installed and maintained overhead and underground electrical power lines and auxiliary equipment.
• Responded to emergencies and outages that required additional labor and assistance for repairs.

• Prepared worksite by setting up required tools and supplies.
• frame new pole on the ground to get ready for pole set.
• set new pole after lineman uses proper cover up and one shot reclosure is in effect.
• pull down guy to spec tie in withe 3/8s pre form.
• dig new pole whole to depth needed for new pole.
• load/unload poles on pole trailer and pull when needed.
• hang and install #2 triplex from transformer to feed house.
• assist lineman in hooking up house services and learn.