M.KONDA MANI

• CAE Analyst with 11 years of Experience. To obtain a challenging career in the field of engineering, which serves to expose my skills in the relevant field.

• Father's Name: Mr. Muni Reddy
• Date of Birth: 06/10/85
• Gender: Male
• Nationality: Indian
• Marital Status: Married

Project : SEAT SYSTEM ON RIGID BED LONGITUDINAL STRENGTH ANALYSIS

Tool Used : LS-DYNA, , HyperWorks, Ansa

Responsibilities:

• Seats are modelled as per guide lines given. Contacts are applied between seat foam and structures. Load are applied at shoulder block, lap block and CG of seat.
• Debug the errors and make as runnable model.
• Post processing results are validated and reports will be generated.
• Following results are validated

            SIR DISPLACEMET

             PRE TENSION BOLT FORCE FOR 60% and 40% SEAT

             FLOOR M10 and M12 BOLT FORCE

             RECLINER MOMENT FOR  60% and 40% SEAT

             SEAT LATCH FORCE

              STRIKER FORCE FOR  60% AND 40% SEAT

              SEAT BELT FORCE

Project : SEAT SYSTEM DYNAMIC STRUCTURAL INTEGRITY SIMULATION

Tool Used : LS-DYNA, , HyperWorks, Ansa

Responsibilities:

• Seats are modelled as per guide lines given. Contacts are applied between seat foam and structures. Load are applied at shoulder block, lap block and CG of seat.
• Debug the errors and make as runnable model.
• Post processing results are validated and reports will be generated.
• Following results are validated

             SEAT BACK ANGLE

              PRE TENSION BOLT FORCE FOR 60% and 40% SEAT

              FLOOR M10 and M12 BOLT FORCE

              RECLINER MOMENT FOR  60% and 40% SEAT

              SEAT LATCH FORCE

              STRIKER FORCE FOR  60% AND 40% SEAT

              SEAT BELT FORCE

Project : FULL VEHICLE

Tool Used : LS-DYNA, RADIOSS, HyperWorks, Ansa

Responsibilities:

• Full Vehicle Integration.
• Deliver the full Vehicle runnable model for the client.
• Need to check and Run the Full Vehicle model with different load cases like Frontal Impact, side Impact, Rear impact.
• Check for the Global energy curves and full vehicle simulation.
• Debug the Model and need to clear the Errors.
• Report Preparation for the Full Vehicle Integration.
• Need to check and create module connections for the full vehicle.
• Predation of Sub-assemblies and to check create inter module connections with full vehicle.
• Quality maintenance.

Full Vehicle Integration with different sub-assemblies and to maintain the connections for the full vehicle, Model checker need to be done and Run the Full vehicle model with different Load cases, need to observe the Global energy curves and the full vehicle simulation.